The Russian Mosin Nagant Forum

Hi everyone. First post in about 13 years here. This forum really set an expectation in my mind to keep as many original milsurps in their original condition which I greatly appreciate now that I am 15 years older!

Below is a 1935 SA 1903 that shoots amazingly well. It was rebarreled in 1942, and I'm sure it was taken apart many times but the stock, laser etching on the bolt, and receiver all match.

My only issue is that it shoots a legitimate 18" high at 150y. Even at 50y it is shooting about 6" high. Any tips?

Looks good!

150 yards for a full power .30 military cartridge is like using a super car to go down the drive to fetch the mail. These rifles were designed to reach out and touch things at 250-300 yards or longer. Use the six O'clock hold on the target, or aim for the belt to hit the chest. You could swap out the sight blade for a taller one if you could find one, but I never bothered with that. I shot a lot of rounds with the M1903, and M1903-A3 as I amassed a collection of these rifles back in the day. I remember guys gluing thin metal shims to the blade, they always fell off eventually. Nice find 2 posts in 13 years? You post like I work, slowly

Those rifles are beautiful.

Darryl

Like they said. 6 o'clock hold, but make sure your rear sight is in the lowest setting.

I do not own a 1903 Springfield, so not in a position to provide first hand advice. However, I have a friend and former coworker who owns several 03 and 03A3 rifles who advises you can buy higher front sights for this condition. You might look at Numrich Gunparts Corporation.

https://www.gunpartscorp.com/

Beautiful 1903, really nice. They sure photograph better in natural light. Question, what ammo are you firing, M2 ball?

I had a buddy record a video of me shooting it and this is the best I can do. The red line is where I’m aiming (notch rear sight at lowest setting) and I’m impacting the red dot.(You can see the grey impact markings slightly next to the red dot) It’s almost 3 feet at that distance. When I aimed at the belt buckle it almost went over my berm.

Still fun though.

I found this on Numerich, it looks much taller but does not say anything about the height. Wonder if I should give it a try?

https://www.gunpartscorp.com/products/524900

For $5 yeah, I'd try it. If it is too tall you can file it down to the correct height.

Thanks for all the help everyone. Will report back.

I do love this rifle. The bolt is so smooth compared to a Mosin, but Mosin's still have a special place in the collection

Side note - I haven't really shopped for milsurps in a while. WHAT HAS HAPPENED TO THE PRICES? I have an Ishevsk 1944 all matching M44 with laminated stock I paid $40.00 for from a pawn shop in 2006 or so. Now that's what? $450 or something?

AchNgnt wrote: ↑Mon Mar 18, 2024 6:40 am Thanks for all the help everyone. Will report back.

I do love this rifle. The bolt is so smooth compared to a Mosin, but Mosin's still have a special place in the collection

Side note - I haven't really shopped for milsurps in a while. WHAT HAS HAPPENED TO THE PRICES? I have an Ishevsk 1944 all matching M44 with laminated stock I paid $40.00 for from a pawn shop in 2006 or so. Now that's what? $450 or something?

Inflation, lack of available cheap imports, increasing numbers of new collectors wanting milsurps who will pay the higher prices. War between Russia and Ukraine pretty much cuts off any possibility of more Mosins and other Soviet WW2 surplus anything coming out of either country. In some cases it looks like they are both arming themselves with these ancient weapons once again. Finland has sent us the bulk of their surplus, in fact they did that over 35 years ago. It's unlikely that there are any more big hoards of bolt action military surplus rifles out there waiting to be brought in that would drive down prices on some types of rifles for a short time.